Inspirational journeys

Follow the stories of academics and their research expeditions

CompTIA Server+ Certification Exam Questions and answer - Part 48

Mary Smith

Tue, 21 Apr 2026

CompTIA Server+ Certification Exam Questions and answer - Part 48

1. A technician is trying to install the operating system on a new server. When the server is powered on,it searches for the installation information on CD and then on the local hard drive. The operating system installation is on a PXE server. Which of the following should the technician change to successfully install the operating system?

A) BIOS settings
B) File system type
C) Firmware version
D) RAID configuration



2. A system administrator needs to install an operating system onto a new server in a remote location using PXE. Which of the following methods will BEST accomplish this?

A) SSH
B) TFTP
C) RDP
D) HTTP



3. A technician correctly powers off and replaces a cache battery on a RAID controller. When the server is powered back up,it restarts but indicates there are no logical disk volumes found. The server halts. Which of the following components should the technician check FIRST?

A) Controller cabling
B) BIOS boot order
C) Cache battery
D) Disk backplane



4. A technician has completed the installation and configuration of a third email server. The technician has configured the firewall to permit email traffic,but the mail is only being received by the two older servers. Which of the following should the technician configure to ensure incoming email will be processed by all three servers?

A) Configure IMAP on the new mail server.
B) Enable NTP to ensure all three servers are synchronized.
C) Add the DNS server option in DHCP.
D) Update the MX record in DNS.



5. A systems administrator has been tasked to set up a new server to assign IP addresses on the network. The network administrator logs into the server,but cannot find the management tool to create a scope. Which of the following MOST likely happened to cause this?

A) The systems administrator configured the wrong NTP server address.
B) The systems administrator did not install the DHCP server role.
C) The systems administrator did not configure the routing and remote access server role.
D) The systems administrator forgot to unblock port 67/68 in the firewall.



1. Right Answer: A
Explanation:

2. Right Answer: B
Explanation:

3. Right Answer: C
Explanation:

4. Right Answer: D
Explanation:

5. Right Answer: B
Explanation:

0 Comments

Leave a comment