1. After installing a second processor and corresponding heatsink into a server,an administrator notices that the new processor is not showing up during POST. Which of the following could be the cause of this issue?
A) The voltage regulator module (VRM) was not installed. B) The DMA setting was not set. C) The power supply is not sufficient to power the server. D) The IRQ setting was not set.
2. An administrator has 120V,150-amp service in the datacenter. Which of the following is the MAXIMUM number of servers with a faceplate rating of 65W that can be racked in the datacenter?
A) 250 B) 275 C) 300 D) 225 E) 200
3. An administrator needs to reconfigure a Linux server's operating system. Which of the following tools can the administrator use to access a command shell over the network? (Select TWO).(Select 2answers)
A) Connect with RDP B) Connect with SSH C) Connect with FTP D) Connect with BASH E) Connect with VNC
4. A datacenter is in a geologically active area and has no earthquake abatement installed. Which of the following drive types is BEST for general server use?
A) USB drives B) High RPM drives C) Solid state drives D) Low RPM drives
5. An administrator is required to backup 250GB nightly utilizing a single LTO2 tape. The administrator reports that the tape drive is running out of available space before the job completes. Which of the following would allow the administrator to backup this data? (Select TWO).(Select 2answers)
A) Replace the LTO2 with LTO3 drive and tapes B) Utilize LTO3 tapes in the existing drive C) Reduce the amount of data on the backup D) Enable compression on the LTO2 drive E) Divide the data and back up half one night and half the next
Leave a comment